Dell 6024, 6024 F Adding Bridge Multicast Address Members

Configuring Switch Information 319
3 Click Apply Changes .
Bridge Multicast
is enabled on the device.
Enabling IGMP Snooping on the Device
1 Open the Multicast Global Parameters page.
2 Select Enable in the IGMP Snooping Status field.
3 Click Apply Changes .
IGMP Snooping is enabled on the device.
Enabling Multicast Forwarding and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast forwarding
and IGMP Snooping as displayed on the
Multicast Support page.
The following is an example of the CLI commands:
Console (config)# bridge multicast filtering
Console (config)# ip igmp snooping
Adding Bridge Multicast Address Members
The Bridge Multicast Group page displays the ports and LAGs attached to the Multicast service
group in the
Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the
port or LAGs joined the Multicast group. Ports can be added either to existing groups or to new
Multicast service groups. The
Bridge Multicast Group page permits new multicast service groups
to be created. The
Bridge Multicast Group page also assigns ports to a specific multicast service
address group.
To open the
Bridge Multicast Group page, click Switch → Multicast Support → Bridge Multicast
Address
in the tree view.
Table 7-31. Multicast Forwarding and Snooping CLI Commands
CLI Command Description
bridge multicast
filtering Enables filtering of Multicast addresses.
ip igmp snooping Enables Internet Group Membership
Protocol (IGMP) snooping.