Operating the Main Remote Control Unit
Signal transmission 
indicator
[DEVICE
SELECTOR]
[
MAIN] 
[8], [1], 
[9], [6], 
[3], [7], [2] 
[CHANNEL +, 
[0 ~ 9] 
[RC SETUP]
[
SAT/CBL]
[
DVD/HDP]
[
VCR/DVR]
[
TV]
[POWER ON]
MACRO Function
This function lets you register a series of operations at a single button.
For example, the amplifier can be turned on, the input source selected, the monitor’s power turned on, the source device’s power turned on and the play mode set all by pressing a single button.
Up to 32 signals each can be registered at [MACRO] (1 ~ 3).
Registering
1 Press and hold in [RC SETUP] for at least 3 seconds.
2 Press [9], [7] and [8], in that order.
The signal transmission indicator flashes twice and the system call registration mode is set.
3Press [MACRO] (1 ~ 3) at which you want to register the signals.
4Press the buttons you want to register in the same sequence as the operations you want to perform.
The signal transmission indicator lights when a button is pressed.
Calling out
1Press [MAIN], to select “MACRO”.
2Press [MACRO] (1 ~ 3) at which the signals were registered.
The registered signals are transmitted in the registered sequence.
Punch Through Function
DVD/HDP (including BD and CD) or VCR/DVR mode buttons can be stored at unused TV or SAT/CBL mode buttons.
For example, when DVD mode buttons are assigned to the TV mode, the DVD mode operations can be performed while in the TV mode.
1 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice.
2 Press [9], [8] and [4], in that order.
The signal transmission indicator flashes twice and the punch
Specifications Troubleshooting Information Control Remote
Signal
transmission indicator
[DEVICE
SELECTOR] 
[MACRO]
Example : Press [POWER ON].
↓
Press [DEVICE SELECTOR] – [DVD/HDP].
↓
Press [1].
b The mode can be switched by pressing [DEVICE SELECTOR].
b Perform the registration procedure for all the buttons you want to register.
5 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed.
NOTE
Registration is not possible in ZONE2, ZONE3, ZONE4 and MACRO modes.
through setting mode is set.
3Press [DEVICE SELECTOR] for the device you want to punch through ([DVD/HDP] or [VCR/DVR]).
4Press the button you want to punch through ([1],
[2], [6], [7], [8], [9] or [3]).
Each time the button is pressed, the signal transmission indicator flashes once.
5Press [DEVICE SELECTOR] for the device you want to punch through ( [TV] or [SAT/CBL]).
6 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed.
NOTE
[0 ~ 9] 
[RC SETUP]
The Punch Through function can only be registered for either TV or SAT/CBL. DVD/HDP punch through may be automatically assigned, depending on the equipment that has been preset to TV and SAT/ CBL.
114