Error Messages
An error message is displayed if it was not possible to complete Audyssey Auto Setup due to speaker placement, the measurement environment, etc. If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
NOTE
Be sure to turn off the power before checking speaker connections.
n When Performing Audyssey Auto Setup Over
Again
Press ui to select “Retry”, and then press ENTER.
nWhen Measuring has Stopped
Press RETURN, the “Cancel auto setup?” prompt is displayed. Press o p and select “Yes”, then press ENTER.
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
Error messages (examples) |
| Error contents |
|
|
| Measures |
| |
| • Correct measurement is not possible | due | to | • When using a subwoofer with | ||||
| inappropriate subwoofer volume. |
|
| (active type), use “SW Level Matching” to adjust | ||||
|
|
|
|
| the subwoofer volume (vpage 38). |
| ||
|
|
|
|
| • When using a | subwoofer without a | ||
|
|
|
|
| amplifier, select “Skip”, and then press ENTER. | |||
|
|
|
| |||||
| • Included setup microphone is not connected. |
| • Connect the included setup microphone to the | |||||
|
|
|
|
| SETUP MIC jack of the |
| ||
| • Not all speakers could be detected. |
|
| • Check the speaker connections. |
| |||
| • The front L speaker was not properly detected. |
|
|
|
| |||
|
|
|
|
|
|
|
| |
| • Too much | noise in the room for | accurate | • Either turn off | any device | generating noise | or | |
| measurements to be made. |
|
| move it away. |
|
|
| |
|
|
|
|
| • Perform again | when the | surroundings | are |
|
|
|
|
| quieter. |
|
|
|
| • Speaker or | subwoofer sound is too | low | for | • Check the speaker installation and the direction in | |||
| accurate measurements to be made. |
|
| which the speakers are facing. |
| |||
|
|
|
|
| • Adjust the subwoofer’s volume. |
| ||
|
|
|
| |||||
| • Displayed speaker could not be detected. |
| • Check the connections of the displayed speaker. | |||||
|
|
|
| |||||
| • Displayed speaker connected with the polarities | • Check the polarities of the displayed speaker. |
| |||||
| reversed. |
|
|
| • For some speakers, this error message may | |||
|
|
|
|
| be displayed even if the speaker is properly | |||
|
|
|
|
| connected. If you are sure the connection is | |||
|
|
|
|
| correct, press ui to select “Skip”, then press | |||
|
|
|
|
| ENTER. |
|
|
|
|
|
|
|
|
|
|
|
|
Specifications Troubleshooting Information Control Remote
Main remote control unit | :Displaying the menu | :Moves the cursor | :Confirm the setting | :Return to previous menu | 37 |
operation buttons | Cancel the menu | (Up/Down/Left/Right) |
|
|
|