Getting

Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)

Information Control Remote zone-Multi Playback Settings Connections Started

STEP6 Store

7Select “Store” andthen press ENTER.

Save the measuring results.

b The save operation takes about 30 seconds to complete.

NOTE

During saving of measuring results, be sure not to turn off the power.

8When the screen shown on the right appears, unplug the setup microphone fromtheAVR-4810CI SETUP MIC jack.

9Select “Exit” and then press ENTER.

nExiting the GUI Menu

Press MENU while the GUI menu is displayed.

The GUI menu display disappears.

NOTE

•If there is a disparity between the results and the connection status, or if an error message is displayed, check the error message against the errors listed in the “Error Messages” section (vpage 37) and perform Audyssey Auto Setup again.

•If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn the AVR-4810CI off, check the speaker connections and repeat the measurement process from the beginning. Turn the AVR-4810CI off, check the speaker connections and repeat the measurement process from the beginning.

•Ifyouchange a speakerpositionor orientation,performAudyssey Auto Setup again to obtain optimal equalizer correction.

Specifications Troubleshooting

After performing Audyssey Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey Auto Setup again.

36

Main remote control unit

:Displaying the menu

:Moves the cursor

:Confirm the setting

:Return to previous menu

 

operation buttons

Cancel the menu

(Up/Down/Left/Right)