Connecting Devices

Control Dock for iPod

Use a DENON control dock for iPod (ASD-1R or ASD-11R, sold separately) to connect the iPod to the AVR-4810CI. For instructions on the control dock for iPod settings, refer to the control dock for iPod’s operating instructions.

Control dock for iPod

"4%3

R L

R L

CD Player

Select the terminal to use and connect the device.

CD player

"6%*0

"6%*0 $0"9*"-

065065

-3

L R

L R

Record Player

Turntable

(MM cartridge)

"6%*0

(/%

065

 

 

L R

Information Control Remote zone-Multi Playback Settings Connections Started Getting

Set as Necessary

Set this to change the input signal to which the input source is assigned.

“Input Assign” (vpage 58)

Set as Necessary

Set other than when iPod is assigned to the VCR (iPod) terminal. “Input Assign” – “iPod dock“ (vpage 60)

•With the default settings, the iPod can be used connected to the VCR (iPod) connector.

•You can also connect the iPod you are using directly to the USB port of the AVR-4810CI (vpage 24 “USB Port”).

•The AVR-4810CI is compatible with record players with an MM cartridge. When you connect to a record player with an MC cartridge, use a commercially available MC head amp or a step-up transformer.

•When you increase the volume without connecting the record player, there may be “booming” noise from the speakers.

NOTE

The SIGNAL GND terminal of the AVR-4810CI is not a safety ground connection. Connect it to reduce noise when noise is excessive. Note that depending on the record player, connecting the ground line may have the reverse effect of increasing noise. In this case, it is not necessary to connect the ground line.

Specifications Troubleshooting

19