Denon AVR-4810CI Preparations

Preparations

Thank you for purchasing this DENON product. To ensure proper operation, please read this owner’s manual carefully before using the product.

After reading them, be sure to keep them for future reference.

Accessories
Check that the following parts are supplied with the product.
q Owner’s manual.......................................................................	1
w Getting started.........................................................................	1
e Warranty (for North America model only)................................	1
r Service station list....................................................................	1
t Power cord (Cord length: Approx. 6.2 ft / 1.9 m).....................	1
y Main remote control unit (RC-1126).........................................	1
u LR6/AA batteries (for RC-1126)................................................	2
i Sub remote control unit (RC-1121)..........................................	1
o R03/AAA batteries (for RC-1121).............................................	2
Q0FM indoor antenna...................................................................	1
Q1AM loop antenna (small, for AM broadcasts)...........................	1
Q2AM loop antenna (large, for HD Radio broadcasts)..................	1
Q3Dipole antenna (for HD Radio broadcasts)...............................	1
Q4Rod antenna for wireless LAN connection..............................	1
Q5Setup microphone
(DM-A409, Cord length: Approx. 25 ft / 7.6 m)........................	1

t y i

Q0 Q1 Q2

Q3 Q4 Q5

About the Remote Control Unit

In addition to the AVR-4810CI, the included main remote control unit (RC-1126) can also be used to operate the equipment listed below.

qDENON system components

wNon-DENON system components

•To operate component products other than DENON, you must set the preset code (vpage 109 “Presetting”).

•If you are using a non-DENON AV device, or if you cannot operate the device even after registering the preset code, memorize the other device’s remote control signal in the AVR-4810CI remote control unit (vpage 113 “Learning Function”).

Inserting the Batteries

qLift the clasp and remove the rear lid.

(RC-1126)(RC-1121)

w Load the two batteries properly as indicated by the marks in the battery compartment.

(RC-1126)(RC-1121)

R03/AAA

LR6/AA

ePut the rear cover back on.

NOTE

•Insert the specified batteries in the remote control unit.

•Replace the batteries with new ones if the set does not operate even when the remote control unit is operated close to the unit. (The supplied batteries are only for verifying operation.)

•When inserting the batteries, be sure to do so in the proper direction, following the “q” and “w” marks in the battery compartment.

•To prevent damage or leakage of battery fluid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not attempt to charge dry batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

•Remove the batteries from the remote control unit if it will not be in use for long periods.

•Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.

Operating Range of the Remote Control Unit

Point the remote control unit at the remote sensor when operating it.

(RC-1121)

30°

30° or

Approx. 23 feet / 7 m(RC-1126)

NOTE

The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.

Specifications Troubleshooting Information Control Remote zone-Multi Playback Settings Connections Started Getting