Emerson E2 operation manual Edit Menu, Entering Setpoints, Navigating the Setup Screen

10.18.2.1 The Edit Menu	parameter stored inside the controller. Setpoints can be
	programmed from any application setup screen.
	To enter setpoints from a Setup screen:
	1.	Press  (SETUP) from the desired applica-
		tion’s Status screen. (If starting from the Home
		screen, move the cursor to the desired applica-
		tion’s value and press to open the Actions
		Menu. Choose Setup. This will take you to the
		Setup screen.)
	2.	Once inside the application’s Setup screen, look
		for the Setpoints option in the index tabs along
		the top of the screen.
	3.	Use  (NEXT TAB) to tab over and the Set-
		points box of your application will open.

Figure 10-46 - Edit Menu

The Edit menu becomes available when you are on a Setup screen and can be opened by pressing  (EDIT). Depending on which Setup option (index tabs) is high- lighted, the Edit menu allows you to change field format- ting using these options:

•Alternate I/O Formats - setting up pointers can change a field to expect a Board:Point, Fixed Value, or Area Ctrl:Application:Property.

•Set Multiple Outputs - allows you to connect an output pointer to multiple input pointers.

•Output Change Delta - the +/- change that must occur at the output before the new value is used.

•Generic Alarm Setup - enables the user to custom- assign alarming parameters in the controller.

•Logging Setup - enables the user to turn logging on for a particular parameter. Note that if “L” appears next to the parameter, default logging has already been enabled for the Logging Group Cell.

•Bypass Setup - Opens screen for bypass input types, which are “Momentary” or “Level” triggered and remain active for a “Bypass Duration”. For example, Time Schedules have two such inputs.

•I/O Mode - toggles between displaying board names and board numbers.

•Setup I/O - allows user to enter an input or output point setup screen.

10.18.2.2 Entering Setpoints

An application setpoint is a user-defined control

Figure 10-47- Setpoints Box

10.18.2.3 Navigating the Setup Screen

Figure 10-48- Typical Setup Screen (RX version shown)

The Setup utility is the interface used to change set-

Set Up Applications Quick Start • 10-27