Emerson operation manual E2 RX/BX/CX I&O Manual Rev 13 14-SEP-2011

Alarm Name	Default	Definition
	Priority
Application Setpoint Has Changed	99	A user has changed a setpoint in one of E2’s applica-
		tions.
Application Was Created	99	A user has created a new application in this E2.
Application Was Deleted	99	A user has deleted an existing application in this E2.
ARTC/MultiFlex RTU Override	20	An override switch on an ARTC/ MultiFlex RTU has
Switch Stuck		been ON for a prolonged period of time, suggesting a
		possible switch failure.
ARTC/MultiFlex RTU Reset From	50	An ARTC/MultiFlex RTU lost power and reset when
Power Failure		power was restored.
Attempt To Write Past Mem. EOB	50	The E2 attempted to write data to memory, but the
		memory was full.
Average Log Stuck-No Memory	15	The Average Log cannot be written because there is
		not enough memory.
Bad Modem	20	The modem on this E2 is not functioning properly.
Battery backed memory lost	30	Battery backed memory loss not due to cleanout.
Batt Runtime Limit	99	Battery runtime has exceeded 80% of the battery life-
		time.
Binding Input To Output Failed	20	A valid connection could not be made between an
		input and an output.
BIOS/BIOS Ext. Update Failed	20	An update to the E2’s BIOS has failed.
BIOS/BIOS Extension Updated	50	The E2’s BIOS was successfully updated.
Can't Set Hardware Clock	20	The E2 is unable to change the time on its hardware
		clock.
Case Cleaning Was Started	User	A case circuit has entered clean mode.
Case Temp Hi Limit Exceeded	User	A single temperature sensor in a Standard Circuit or
		Case Control Circuit is recording a temperature
		higher than its defined case temperature high set-
		point.
Case Temp Low Limit Exceeded	User	A single temperature sensor in a Standard Circuit or
		Case Control Circuit is recording a temperature lower
		than its defined case temperature low setpoint.
Cell Config Not Restored	15	E2’s attempt to restore configuration data to its appli-
		cations has failed.
Cell Create Failed For Restore	20	E2 attempted to create new applications as part of the
		configuration restoration process and failed to do so
		successfully.
Checkit Sensor Has Failed	User	A Checkit sensor is returning an invalid temperature
		value, indicating a sensor failure.
Checkit Sensor Is Alarming	User	A Checkit sensor on a Suction Group application is
		recording a high temperature.
Checkit Sensor Is In Notice	User	A Checkit sensor’s temperature is above its pro-
		grammed notice setpoint.

C-2 • E2 RX/BX/CX I&O Manual 026-1610 Rev 13 14-SEP-2011