Emerson operation manual E2 Hardware Setup

3.2.1	Single/Double Enclosures		3-3
3.2.2 Boards Without Enclosures (Snap Track)			3-4
3.3 ECHELON DEVICES			3-4
3.3.1	16AIe and 8ROe		3-4
3.3.2 CC-100 Case Controller and CS-100 Case Circuit Controller			3-5
3.3.3	ESR8 (Discontinued)		3-5
3.3.4	MultiFlex ESR		3-5
3.3.5	TD3		3-5
3.4 MODEM/COMMUNICATION EXPANSION CARD MOUNTING (NEW PROCESSOR BOARD)			3-5
3.4.1 Mounting PC-104 Cards in E2 (Previous Generation Processor Board)			3-6
	3.4.1.1	The Internal Modem	3-6
3.4.2 Two-Channel and Four-Channel Repeaters			3-6
	3.4.2.1	Mounting Repeaters Overview	3-6
	3.4.2.2 Mounting the Two-Channel Repeater		3-6
	3.4.2.3 Mounting the Four-Channel Repeater		3-7
3.5 SENSORS AND TRANSDUCERS			3-7
3.5.1	Pressure Transducers		3-7
	3.5.1.1	Mounting	3-7
3.5.2	Inside Temperature Sensor		3-7
	3.5.2.1	Location	3-7
	3.5.2.2	Mounting	3-8
3.5.3	Outside Temperature Sensor		3-8
	3.5.3.1	Location	3-8
	3.5.3.2	Mounting	3-8
3.5.4	Insertion Temperature Probe		3-8
	3.5.4.1	Location	3-8
	3.5.4.2	Mounting	3-8
3.5.5 Supply and Return Air Sensors			3-8
3.5.6 Refrigeration System Temperature Probes and Sensors			3-9
	3.5.6.1	Location	3-9
	3.5.6.2 Mounting Bullet and Pipe Mount Sensors		3-9
3.5.7	Product Temperature Probes		3-9
3.5.8 Humidity Sensors and Humidistats			3-9
	3.5.8.1	Indoor RH Sensor	3-9
	3.5.8.2	Outdoor RH Sensors	3-10
	3.5.8.3 Duct-mounted Insertion RH Probe		3-10
3.5.9	Dewpoint Probe		3-11
	3.5.9.1	Location	3-11
	3.5.9.2	Mounting	3-11
3.5.10	Light Level Sensor		3-11
	3.5.10.1	Location	3-11
	3.5.10.2	Mounting	3-11
3.5.11	Liquid Level Sensors		3-11
3.5.12	Refrigerant Leak Detectors		3-11
4 E2 HARDWARE SETUP			4-1
4.1 SETTING UP THE E2			4-1
4.1.1	Enclosure		4-1
4.1.2	Main Processor Board		4-1
4.1.3 Main Processor Board (Previous Version)			4-2
4.1.4	Power Interface Board		4-2
4.2 POWERING THE E2			4-2
4.2.1	RS485 Ports		4-2
4.2.2	RS485 Jumpers		4-2
4.2.3	Echelon Network Connect		4-2

vi • Table of Contents 026-1610 Rev 13 14-SEP-2011