Emerson E2 operation manual Retrofit Mounting, Standard Mount Inside Rear of Enclosure

to the cut out (four screws and four nuts are included), but the plate is equipped with a total of 14 holes for the best possible fit.

Figure 3-3- Standard Mount (Inside Rear of Enclosure)

Figure 3-4- E2 Recess Mount Hole Locations

3.1.3Retrofit Mounting

The retrofit mounting plate and bracket allow the E2 to be mounted where previous generation controllers (Ein- stein or REFLECS) were. These two options allow con- version of the flush-mounted Einstein and the side- mounted REFLECS.

Figure 3-5shows the low-profile conversion mount plate that allows a flush-mounted Einstein to be converted to a low-profile mount. The plate slides over the back of the E2 and is attached using the four holes pictured closest

Figure 3-5- Conversion Plate for Flush Mount

Figure 3-6- Conversion Bracket for REFLECS Side Mount

Figure 3-6shows the conversion bracket that allows a side-mounted REFLECS to be converted to a side- mounted E2. The conversion bracket is attached to the back of the E2 using the two holes at the top and bottom of the bracket, and aligning the oval openings with the oval cut-outs in the back of the E2 case. Once the E2 is attached to the conversion bracket, use the two holes in either side of the conversion bracket (depending on which side is needed) to mount the E2 to the wall and replace the REFLECS controller.

3-2 • E2 RX/BX/CX I&O Manual 026-1610 Rev 13 14-SEP-2011