Emerson E2 operation manual Appendix C Alarm Advisory Messages C-11

Alarm Name	Default	Definition
	Priority
Normal Low Limit Exceeded	User	An analog value has fallen below its programmed Lo
		Limit setpoint.
Not Enough Backed Memory	10	The E2 tried to save data to the battery-backed mem-
		ory, but the memory was full.
Not Enough Flash Memory	20	The E2 tried to save data to the flash memory, but the
		memory was full.
Not Enough Memory	10	The E2 tried to save data to unbacked memory, but
		the memory was full.
Not Enough Scatch Pad Memory	50	The E2 tried to save data to the scratch pad memory,
		but the memory was full.
Notice Limit Exceeded	User	An analog sensor’s programmed notice limit has
		been exceeded.
Num. Of Events Exceeded Limit	User	A digital value has transitioned ON more times than
		its defined Number of Events setpoint.
Occupied Hi Limit Exceeded	User	An analog value has risen above its defined high limit
		setpoint during OCCUPIED mode.
Occupied Low Limit Exceeded	User	An analog value has fallen below its defined low
		limit setpoint during the OCCUPIED mode.
Off Time Exceeded Limit	User	A digital value has been OFF longer than its defined
		Time Off Last setpoint.
Oil Failure Occurred	User	An oil sensor for a compressor has detected a failure.
On Time Exceeded Limit	User	A digital value has been ON longer than its defined
		Time On Last setpoint.
Open Wire	30	MultiFlex ESR controller has detected an open wire
		on the valve input.
Overcurrent	30	MultiFlex ESR controller has detected an overcurrent
		condition on the valve.
Override Log lost - CRC Error	20	An internal error in the E2 has resulted in a loss of the
		override log.
Override Lost Output Cleared	20	A user tried to override an output on a CC-100, RT-
		100, or similar Echelon device, but the override was
		not performed successfully. Try the override com-
		mand again. If this alarm persists, call Retail Solu-
		tions service.
Override Operation Didn't Take	20	The E2 tried to carry out an override and was unsuc-
		cessful.
Override State Not Restored	50	An overridden input or output has remained in the
		override state longer than its programmed time.
Pad Memory Corrupted - Reboot	30	A problem with memory has resulted in a reset of the
		E2.
Part Cnfg Loss-Ptr	15	Due to an internal error, part of E2’s configuration
		data has been lost.

Appendix C: Alarm Advisory Messages • C-11