Emerson E2 operation manual Appendix C Alarm Advisory Messages C-3

Alarm Name	Default	Definition
	Priority
Comb Temp Hi Limit Exceeded	User	The combined temperature of an entire Standard Cir-
		cuit or Case Control Circuit has risen above its pro-
		grammed high temperature setpoint.
Comb Temp Low Limit Exceeded	User	The combined temperature of an entire Standard Cir-
		cuit or Case Control Circuit has fallen below its pro-
		grammed low temperature setpoint.
Commission failed-chk network	50	Commission of Echelon controller failed; binding of
		NV was not successful. Check the Echelon network.
Communication Port 1 Is Down	20	E2 cannot communicate with the RS232 port on the
		E2 main board. The E2 main board likely needs
		repair or replacement.
Communication Port 2 Is Down	20	E2 cannot communicate with the RS485 network port
		on the E2 main board. The E2 main board likely
		needs repair or replacement.
Communication Port 3 Is Down	20	E2 cannot communicate with the modem slot on the
		E2. The E2 main board likely needs repair or replace-
		ment.
Communication Port 4 Is Down	20	COM4 is used by service personnel to attach hard-
		ware used in test or debug functions. This alarm indi-
		cates the port that allows E2 to communicate with
		these devices is faulty. The E2 board likely needs
		repair or replacement.
Communication Port 6 is down	20	E2 cannot communicate with port 6 on the E2 main
		board.
Completed Firmware Update	50	The E2’s firmware was successfully updated.
Config Loss - Chg In Tmpl Rev.	15	Due to a difference between configuration templates
		in a previous E2 version and templates in the current
		version, configuration data could not be restored.
Config Loss-CRC Error	15	Due to an internal error, E2 has lost configuration
		data.
Config Loss-File CRC Error	15	Due to an internal error, E2 has lost configuration
		data.
Config Not Saved To Flash	20	E2 could not save configuration data to flash mem-
		ory.
Controller (or Device) Absent From	20	The current E2 could not find the specified E2, I/O
Network		board, or Echelon controller
Controller Reset	50	An ARTC/MultiFlex RTU has gone through a reset.
Controller Shutdown	50	The E2 has gone through a shutdown.
Controller Startup	50	The E2 has re-started after a shutdown.

Appendix C: Alarm Advisory Messages • C-3