Emerson Process Management 53eA instruction manual Choices Factory Settings Configure

MODEL 54eA	SECTION 5.0
	SOFTWARE CONFIGURATION

TABLE 5-1. Program Settings List			(continued)
	ITEM			CHOICES	FACTORY SETTINGS
CONFIGURE
A. Display options (Section 5.5)
1.	Measurement	Oxygen, ozone, free chlorine, total chlorine, monochloramine			Oxygen
2.	Sensor (Oxygen only)		Rosemount standard, Rosemount biopharm, or		Rosemount standard
				other steam sterilizable
3.	Units (Oxygen only)			ppm, ppb, % saturation	ppm
4. Temperature units				°C or °F	°C
5.	Output 1			mA or % of full scale	mA
6.	Output 2			mA or % of full scale	mA
7.	Language		English, Français, Español, Deutsch, Italiano		English
8.	Main display left			See section 5.5	Sensor current
9.	Main display right			See section 5.5	Output 1 current
10 Display contrast				00-99 (darkest)	50
11. Test timeout				On or off	On
12. Timeout value				1 to 60 min	10 min
B Outputs (Section 5.6)
1.	Output 1 Control
	a. Measurement		Oxygen, chlorine, ozone, pH, or temperature		Oxygen
	b. Control			Normal or PID	Normal
2.	Output 1 Setup (normal)
	a. Current			4-20 mA or 0-20 mA*	4-20 mA
	b. Dampening			0-299 sec	0 sec
	c. Hold mode			Hold last value or go to fixed value	Hold last value
	d. Fixed hold value			0-22 mA	21 mA
	e. Fault value			0-22 mA	22 mA
3.	Output 1 Setup (PID)
	a. Proportional			0 to 299.9%	100 %
	b. Integral			0 to 2999 sec	0 sec
	c. Derivative			0 to 299.9%	0/0%
4.	Output 2 Control
	a. Measurement		Oxygen, chlorine, ozone, pH, or temperature		Temperature
	b. Control			Normal or PID	Normal
5.	Output 2 Setup (normal)			See output 1	See output 1
6.	Output 2 Setup (PID)			See output 1	See output 1
7.	Hold feature			Enable, disable, or 20 min timeout	Disable
C. Alarms (Section 5.7)
1.	Alarm 1 Control
	a. Activation method		Oxygen, chlorine, ozone, temperature, pH		Oxygen
	b. Control mode			Normal or TPC	Normal
2.	Alarm 1 setup (normal)
	a. Configuration			Low, high, or off	High
	b. Hysteresis
	if oxygen (ppm)			0 to 20 ppm	0 ppm
	if oxygen (ppb)			0 to 999 ppb	0 ppb
	if oxygen (% saturation)			0 to 200%	0%
	if chlorine, monochloramine, or ozone			-9999 to 9999 ppm	0 ppm
	if pH			0 to 14.00	0 pH
	if temperature			0 to 10°C	0.1°C
	c. Delay time			0-99 sec	0 sec
	d. Relay fault			none, open, closed	None

*Option-09, HART-enabled version operates at 4-20 mA only on output 1.

18 Continued on the following page