Emulex LP1150-F4 user manual Master Security Client Situations

Table 5: Error Message Situations

Situation	Resolution
The first time the Security Configurator is started in	Click OK on the message and complete the ACG setup.
an unsecure environment, the following message is	The system on which the Security Configurator is running
displayed: “This utility is running on an unsecure	will become the MSC.
system. Continuing will allow you to set up a new
security configuration making this system the
Master Client System.”
When I start the Security Configurator on a Backup	Because each Backup Master system receives all the
Master system, the following message is displayed:	updates that the MSC makes to the security configuration,
“Warning: This system is a backup master client	the Backup Master systems must be online when the
system. Therefore you will only be able to view the	Security Configurator is running on the MSC. Otherwise,
security configuration. To make changes, you will	updates to the security configuration are not reflected to
need to run this utility on the master client system.”	the Backup Master. If the Backup Master becomes the
	MSC, corruption of the security configuration may occur.
	Click OK to close the message.

Master Security Client Situations

Table 6: Master Security Client Situations

Situation	Resolution
The MSC is no longer bootable or able to	You must reassign a Backup Master as the new MSC
connect to the FC network.	from the Backup Master.
	Warning: Use this procedure only if the MSC cannot
	relinquish control to a Backup Master. For
	example, if the MSC is no longer bootable or
	able to connect to the FC network. Under any
	other circumstances, if the Backup Master
	takes over as the MSC and the MSC is still
	running or comes back online later, there will
	be two MSCs for the same security
	configuration. This will eventually lead to
	corruption of the security configuration.
New Keys Were Generated While Servers Were	The servers are no longer part of the security
Offline. A "Generate New Keys" operation was	configuration. In order to reset the security on the
performed while one or more of the servers were	affected servers, you must contact Emulex Technical
offline. Now those servers can no longer access the	Support to receive a special application and instructions
HBAnyware Security Configurator or the	on the reset procedure. After the servers have been
HBAnyware utility.	reset, they can be added back into the security topology
	by the MSC.
	Note: If the server was also a client to an ASG, then
	when you run the Security Configurator on the
	MSC or a parent client of this client, its label in the
	ASG tree of the Access Sub-Group tab will be "-
	ASG (Offline Client) -". You must delete the ASG
	(after deleting the child ASGs) and recreate the
	ASG configuration of this client and its child
	ASGs.

Solaris SFS Driver User Manual Page 137