/pci@8,600000/lpfc@2

.

.

.

{0} ok " /pci@8,600000/lpfc@2" select-dev {0} ok set-sfs-boot

{0} ok reset-all

e.Boot the system to the OS.

6.Define or designate an alternate boot drive for DAS boot through SFS and the Sun or Emulex HBA. If the alternate boot drive is fabric-attached, configure the storage (by using a command such as cfgadm -c configure <APID>).

7.Use the format command to identify the alternate boot drive and take note of its path because will be used to boot from the added HBA.

8.Use the ufsdump and ufsrestore commands (see the Emulex Remote Boot Guide for SFS Drivers) to create a fabric boot disk. Follow the instructions until complete.

9.Shut down the server and get to the ok prompt.

10.Issue the set-sfs-boot lpfc to emlx. Changes will Example:

command to change the remaining Emulex HBAs device paths from not take effect until the system is reset.

{0} ok show-devs

.

.

.

/pci@8,600000/lpfc@2

.

.

.

{0} ok " /pci@8,600000/lpfc@2" select-dev

^

Space required {0} ok set-sfs-boot {0} ok unselect-dev

Repeat for each HBA in the system. Type reset-all,then boot the system to the OS.

11.Boot the new device:

For a Sun-branded boot HBA:

{0} ok boot /pci@8,600000/SUNW,emlxs@2/fp@0,0/disk@w21000004cf720664,0:a

For an Emulex boot HBA:

{0} ok boot /pci@8,600000/emlx@2/fp@0,0/disk@w21000004cf720664,0:a

12.Use emlxdrv to migrate all supported lpfc-attached HBAs to emlxs.

13.Reconfigure all FC targets to your emlxs-attached HBAs.

14.Remove any HBAs that are not supported by emlxs (such as LP8000).

15.Uninstall lpfc: login as root or su to root, then type pkgrm lpfc.

Solaris SFS Driver User Manual

Page 167

Page 174
Image 174
Emulex LP1150-F4 user manual Shut down the server and get to the ok prompt, For an Emulex boot HBA