Emulex LP1150-F4 user manual Resethardcore, Diag test parameters or diag code cmdcode hex

reset_hard_core

Forces the HBA to perform a core firmware reset.

Example:

emlxadm> reset_hard_core

Done.

diag <test [parameters]> or diag code <cmd_code (hex)>

Performs the specified diagnostics function or command code on the HBA port. This command provides support for the Emulex-specific tests shown below, or generic support to issue an HBA-specific diagnostic code (in hexadecimal) to any third party HBA.

Tests:
emlx_biu [pattern]	- Performs the		Bus Interface Unit test.
emlx_echo <did> [pattern]	- Performs	the	ECHO test to a specified port id.
emlx_post	- Performs	the	Power-On Self Tests.

Parameters:

pattern - 4 byte hex pattern to be used for test. (e.g. 0xA5A5A5A5)

Example:

emlxadm> diag emlx_biu

Result: EMLX_DIAG_BIU: Operation successful.

or

emlxadm> diag emlx_echo fffffc

Result: EMLX_DIAG_ECHO: Operation successful.

or

emlxadm> diag emlx_post

Result: EMLX_DIAG_POST: Operation successful.

Example:

emlxadm> diag code 0x4526

Result: CODE(0x4526): 16 (0x10)

Note: The return status from the HBA is displayed in decimal and hexadecimal if the diagnostic code is valid for the HBA. No interpretation of the return status is provided.

Solaris SFS Driver User Manual Page 114