Emulex LP1150-F4 user manual Solaris SFS and lpfc Driver Parameter Cross-Reference

Table 1: Solaris SFS and lpfc Driver Parameter Cross-Reference (Continued)

Solaris SFS/	Solaris SFS/HBAnyware	Related	lpfc Min/Max, Default and
HBAnyware	Min/Max, Defaults and	lpfc		Comments
			Description
Parameter	Description	Parameter
network-on	Min:0 (Disables)	network-on	Min:0 (Disables)	The lpfc
	Max:1 (Enables)		Max:1 (Enables)	parameter
	Default:1		Default:1	enables or
	Description: Enables or		Description: Controls	disables FCIP on
	disables IP networking		whether lpfc provides IP	the Emulex HBA.
	support in the driver.		networking functionality over
			FC. This variable is Boolean:
			when zero, IP networking is
			disabled: when non-zero, IP
			networking is enabled.
num-iocbs	Min:128	num-bufs	Min:64
	Max:1024		Max:128
	Default = 1024		Default = 128
	Description: Sets the		Description: Specifies the
	number of iocb buffers to		number of command buffers
	allocate.		to allocate. These buffers
			are used for Fibre Channel
			Extended Link Services
			(ELS) and one for each FCP
			command issued in SLI-2
			mode. If you want to queue
			lots of FCP commands to the
			adapter, then you should
			increase num-bufs for better
			performance. These buffers
			consume physical memory
			and are also used by the
			device driver to process loop
			initialization and rediscovery
			activities. Important: The
			driver must always be
			configured with at least
			several dozen ELS
			command buffers; Emulex
			recommends at least 128.
num-nodes	Min:2	N/A	N/A
	Max:512
	Default:512
	Description: Number of FC
	nodes (NPorts) the driver
	will support.

Solaris SFS Driver User Manual Page 16