Emulex LP1150-F4 user manual Solaris SFS and lpfc Driver Parameter Cross-Reference

Table 1: Solaris SFS and lpfc Driver Parameter Cross-Reference (Continued)

Solaris SFS/	Solaris SFS/HBAnyware	Related	lpfc Min/Max, Default and
HBAnyware	Min/Max, Defaults and	lpfc		Comments
			Description
Parameter	Description	Parameter
pm-support	0 = Disables power	N/A	N/A
	management support in the
	driver.
	1 = Enables power
	management support in the
	driver.
	Default: 0
	Description: Enable/Disable
	power management support
	in the driver
topology	0 = loop, if it fails attempt pt-	topology	0x0 = loop, if it fails attempt	The topology
	to-pt		pt-to-pt	parameter
	2 = pt-to-pt only		0x2 = pt-to-pt only	controls the
	4 = loop only		0x4 = loop only	protocol (not
	6 = pt-to-pt, if it fails attempt		0x6 = pt-to-pt, if it fails	physical)
	loop		attempt loop	topology
	Default: 0		Default: 0	attempted by the
	Description: Link topology		Description: Controls the FC	driver.
	for initializing the Fibre		topology expected by lpfc at
	Channel connection. Set pt-		boot time. FC offers pt-to-pt,
	to-pt if you want to run as an		fabric and arbitrated loop
	N_Port. Set loop if you want		topologies. To make the
	to run as an NL_Port.		adapter operate as an
			N_Port, select pt-to-pt mode
			(used for N_Port to F_Port
			and N_Port to N_Port
			connections). To make the
			adapter operate as an
			NL_Port, select loop mode
			(used for private loop and
			public loop topologies). The
			driver will reject an attempt
			to set the topology to a value
			not in the above list. The
			auto-topology settings 0 and
			6 will not work unless the
			adapter is using firmware
			version 3.20 or higher.
ub-bufs	Min:40	N/A	N/A
	Max:16320
	Default:1000
	Description: Sets the
	number of unsolicited
	buffers to be allocated.

Solaris SFS Driver User Manual Page 17