Setting Driver Parameters for an HBA

To change the driver parameters for an HBA:

1.Start the HBAnyware utility.

2.Do one of the following:

From the menu bar, click View, then click Sort by Host Name.

From the toolbar, click the Sort by Host Name button.

3.In the discovery-tree, select the HBA whose parameters you wish to change.

4.Select the Driver Parameters tab (see Figure 24). The parameter values for the selected HBA are displayed.

Figure 24: HBAnyware Utility, HBA Selected - Driver Parameters Tab

5.In the Driver Parameters tab, click the parameter that you want to change. A description of the parameter appears on the right side of the dialog box.

6.Enter a new value in the Value field in the same hexadecimal or decimal format as the current value. If the current value is in hexadecimal format, it is prefaced by "0x" (for example, 0x2d). You may enter a new hexadecimal value without the "0x". For example, if you enter ff10, this value is interpreted and displayed as "0xff10".

7.If you want the change to be temporary (causing the parameter to revert to its last permanent setting when the system is rebooted), check the "Make change temporary" box. This option is available only for dynamic parameters.

8.If you are making changes to multiple parameters, and you want all the changes to be temporary, check the "Make all changes temporary" box. This setting overrides the setting of the "Make change temporary" box. Only dynamic parameters can be made temporary.

9.Click Apply.

Solaris SFS Driver User Manual

Page 61

Page 68
Image 68
Emulex LP1150-F4 user manual Setting Driver Parameters for an HBA, HBAnyware Utility, HBA Selected Driver Parameters Tab