Emulex LP1150-F4 user manual SetBeacon, PostTest, EchoTest

SetBeacon

Syntax: HBACMD setbeacon <wwpn> <state>

Description: Sets the current beacon status for the HBA specified by the WWPN. To set the current beacon status for HBA 10:00:00:00:c9:2e:51:2e to off, type:

hbacmd setbeacon 10:00:00:00:c9:2e:51:2e 0

To set the current beacon status for HBA 10:00:00:00:c9:2e:51:2e to on, type:

hbacmd setbeacon 10:00:00:00:c9:2e:51:2e 1

Possible responses are:

Beacon State successfully set to On

Beacons State successfully set to Off

Unable to get Beacon state, error 1

Beaconing not supported on host or adapter

Parameters:

WWPN -The World Wide Port Name of the HBA whose beacon status you want to set. This HBA can be either local or remote.

State - The new state of the beacon: 0 = beacon OFF, 1= beacon ON

PostTest

Syntax: HBACMD posttest <wwpn>

Description: Runs the POST test on the HBA specified by the WWPN. Support for remote HBA is out-of- band (Ethernet) only. To run the POST test for HBA 10:00:00:00:c9:2e:51:2e, type:

hbacmd posttest 10:00:00:00:c9:2e:51:2e

Sample response:

Running POST, polling for results.....

Power On Self Test Succeeded;time to execute = 8928 ms

Parameters:

WWPN - The World Wide Port Name of the HBA on which to run the POST test.

EchoTest

Syntax: HBACMD echotest <wwpn1> <wwpn2> <count> <StopOnError>

Description: Runs the echo test on the HBAs specified by the WWPN1 and WWPN2.

Note: Support for remote HBA is out-of-band (Ethernet) only. The EchoTest command will fail if the target WWPN does not support the ECHO ELS command.

To run the echo test for HBA 10:00:00:00:c9:2e:51:2e, type:

hbacmd echotest 10:00:00:00:c9:2e:51:2e 10:00:00:00:c9:2e:51:45 10 1

Sample response:

Echo test: polling for results......

Echo test succeeded; time to execute = 53 ms.

Parameters:

WWPN1 - The World Wide Port Name of the originating HBA.

WWPN2 - The World Wide Port Name of the destination (echoing) HBA.

Solaris SFS Driver User Manual Page 33