Emulex LP1150-F4 Migrating a Configuration with FC Boot, Migrating Non-emlxs HBAs to emlxs HBAs

11.Configure any targets that were used with the lpfc driver (cfgadm -ato display the target list, cfgadm -c configure <ApId> to configure the ApId's storage). The ApId can also be referenced in the /kernel/drv/lpfc.conf file (for example,

fcp-bind-WWPN="200400a0b816dc52:lpfc3t4" could be configured by typing cfgadm -c con- figure c6::200400a0b816dc52)

12.Edit the /etc/vfstab file and replace the sd pathname (for example, c3t4d1s6) to the ssd pathname (for example, c6t200400A0B816DC52d1s6).

13.Redeploy all your targets to the new HBAs following the instructions in the SAN Foundation Software 4.4 Configuration Manual.

14.Remove older adapters that are not supported by emlxs.

15.Uninstall HBAnyware and lpfc as follows:

login as root or su to root, then type pkgrm HBAnyware lpfc.

Migrating a Configuration with FC Boot

Migrating Non-emlxs HBAs to emlxs HBAs

This case applies if you are currently running only HBAs that are not supported with emlxs, such as LP8000, and migrating to Sun-branded or FCA-recognized Emulex-branded HBAs. In this case, the migration involves procuring emlxs-recognized Sun-branded or Emulex HBAs.

To migrate non-Emulex HBAs to Emulex HBAs:

1.Back up all data and system disks.

2.Install SFS 4.4.7 or higher. It will not recognize any adapters because your existing HBAs remain lpfc-attached.

3.Shut down the system.

4.Install your new Sun-branded or Emulex HBA. Sun-branded HBAs will attach to the Leadville driver (emlxs). Emulex HBAs will attach to the Emulex SD driver (lpfc).

5.Boot the OS.

If you are migrating from one Emulex HBA family to a different family, perform the following additional steps. Otherwise, skip to step 6.

a.Identify the device path of the new boot drive, using the following format:

# format

.

.

.

/pci@8,600000/lpfc@2/sd@1,0

.

.

.

b.Use emlxdrv to change only the migrating lpfc-attached HBA family to emlxs. Do not migrate the boot lpfc adapter's family.

c.Boot the system to the ok prompt

d.Issue the set-sfs-bootcommand to change the remaining Emulex HBA device paths from lpfc to emlx:

{0} ok show-devs

.

.

.

Solaris SFS Driver User Manual Page 166