Epson C I - 4 0 4 0, C I - 4 0 5 0 user manual Cutting V-POS, Uni-Direct.CMD

Configuring the printer

SCUTTING V-POS

This parameter can be used to compensate mechanical tolerances which may cause a misalignment between the perforation edge of a continuous form and the tear-off position as well as the cutting position, in case the cutting option is installed.

If no cutting device is mounted the value of CUTTING V-POSwill influence the TEAR-OFF Position.

The range within which variations can be met is - 15/60" to + 16/60", where "-" is up the page and "+" is further down the page.

The following table shows the possible values in inch and millimetres.

Note: If, for some reason, it is not desired to cut exactly on the perforation it is very important to cut below the perforation of the printed page. If the paper is cut above the perforation the remaining paper can easily bend and cause a paper jam. Do not cut through a label as the blade would get dirty by the glue.

+/- 1	= +/- 1/60"	= +/- 0,42 mm	+/-	9	=	+/- 9/60"	= +/- 3,81 mm
+/- 2	= +/- 2/60"	= +/- 0,85 mm	+/- 10 =			+/- 10/60"	= +/- 4,23 mm
+/- 3	= +/- 3/60"	= +/- 1,27 mm	+/- 11 =			+/- 11/60"	= +/- 4,66 mm
+/- 4	= +/- 4/60"	= +/- 1,69 mm	+/- 12 =			+/- 12/60"	= +/- 5,08 mm
+/- 5	= +/- 5/60"	= +/- 2,12 mm	+/- 13		=	+/- 13/60"	= +/- 5,50 mm
+/- 6	= +/- 6/60"	= +/- 2,54 mm	+/- 14		=	+/- 14/60"	= +/- 5,93 mm
+/- 7	= +/- 7/60"	= +/- 2,96 mm	+/- 15		=	+/- 15/60"	= +/- 6,35 mm
+/- 8	= +/- 8/60"	= +/- 3,39 mm	+	16 =		+ 16/60"	= + 6,77 mm

SUni-Direct.CMD

If NO is selected, commands for uni-directional printing will be ignored. The default setting of YES means that commands will be carried out to switch from bi-directional to uni-directional or vice versa.

3-18