INTERIOR 24/10/03 12:49 Página 19
PROBLEM:
There is no steam released by the operating valve.
REASON:
1.The pressure cooker is not properly locked.
2.There is not enough liquid in the cooker.
3.The rubber gasket is not in place, or is dirty or worn.
4.The burner heat is not high enough.
5.The valve is dirty and/or obstructed.
SOLUTION:
1.Slide the pressure lock up towards the lid.
2.Make sure there is enough liquid.
3.Make sure the rubber gasket is clean and well positioned before using the pressure cooker. After continued use, the rubber gasket will begin to wear and should be replaced approximately once a year or more often if the pressure cooker is used frequently.
4.Turn up the heat until a gentle, steady stream of steam is released from the operating valve.
5.The valve can become dirty when cooking foods that have a tendency to foam, such as dried beans. Clean the valve periodically.
PROBLEM:
Pressure does not
REASON:
1.Not enough liquid.
2.The pressure cooker was not properly closed.
3.The valve is dirty and/or obstructed.
4.The rubber gasket is not in place, or is dirty or worn.
SOLUTION:
1.Always use the appropriate amount of liquid called for in the recipe. This amount should never be less than 1/2
cup. However, never fill the pressure cooker more than half full with liquids.
2.Following the instructions given in this manual, close the pressure cooker so that a tight seal is created, which will allow for adequate pressure
3.The valve can become dirty when cooking foods that have a tendency to foam, such as dried beans. Clean the valve periodically.
4.Make sure the rubber gasket is clean and well positioned before using the pressure cooker. After continued use, the rubber gasket will begin to wear and should be replaced approximately once a year or more often if the pressure cooker is used frequently.
PROBLEM:
1.A gentle, steady stream of steam is released from the operating valve and small drops of water condensation collect on the lid.
2.A large, continuous amount of steam is escaping from the operating valve with or without drops of condensation.
REASON:
1.When used properly, the operating valve will release a gentle steady stream of steam as well as some drops of condensed water on the lid.
2.a) The burner heat is too high.
b)The valve is dirty.
c)The safety valve is malfunctioning.
SOLUTION:
1.Normal operation.
2.a) Lower the heat so that only a gentle, steady stream of steam is released.
b)Check the valve to see if there are any remaining food particles.
c)The safety valve must be replaced. Contact Fagor America Customer Service Dept. at the address and/ or phone number provided in the warranty information.
19
