Force10 Networks 100-00055-01 manual Pnic help

pnic help

Syntax

Command

History

Example

Display a list of all available commands, their syntax, and descriptions.

pnic help

Version 2.3.0.0 Introduced

Figure 56 pnic help Command Example

[root@localhost SW]# pnic help

No card number specified. Assuming card 0

Usage: pnic function_command <card_num> <channel_num> <force_options>

pnic aggregate-mode-disable <0...5> pnic apply-firmwares <0...5> <-f> pnic capture-on <0...5>

pnic compilerules <0...5>

pnic default-drop-enable <0...5> pnic getmachashindex <0...5> pnic linkdown <0...5> <0/1> pnic loadconf <0...5>

pnic loadpassblock <0...5>

pnic macrewrite-off <0...5> <0/1> pnic params <0...5>

pnic passive-mode-disable <0...5> pnic showconf <0...5>

pnic sguil-sensor-start pnic start <0...5>

pnic temp-mem-disable <0...5> pnic updatemacvalue <0...5> pnic web-gui-start

pnic help

pnic aggregate-mode-enable <0...5> pnic capture-off <0...5>

pnic cardstatus <0...5>

pnic default-drop-disable <0...5> pnic diag <0...5>

pnic gui <0...5>

pnic linkup <0...5> <0/1> pnic loadeproms <0...5> pnic loadrules <0...5>

pnic macrewrite-on <0...5> <0/1> pnic passive-mode-enable <0...5> pnic restart <0...5> <-f>

pnic show-firmwares pnic sguil-sensor-stop pnic stop <0...5>

pnic temp-mem-enable <0...5> pnic version

pnic web-gui-stop

Note:	: Option. Default (blank) values are "0"
<>
<card_num>	: Select from 0, 1, 2, 3, 4, or 5
<channel_num>	: Select from 0, or 1
<force_option> : This option will skip the firmware revision check
Command Help:
aggregate-mode-enable		Map both client-to-server and server-to-client traffic
on a channel		to the same flow state entry.
aggregate-mode-disable
		Map client-to-server and server-to-client traffic from
separate		channels to different flow state entries.
apply-firmwares
		Apply the selected firmware to the link that is
currently in use or		for loading
capture-off(off)
		Disable the capture of the packets via DMA.
capture-on(on)		Enable the capture of the packets via DMA.
cardstatus		Display the status of the ports, the revision number
of the PCI-X		FPGA, and the revision number of the Master FPGA.
compilerules
		Transform the dynamic Snort rules contained in /usr/
local/pnic/0/		rules.custom into binary code suitable for the DPI
processor.
		Enable firewall functionality.
default-drop-enable
default-drop-disable		Disable firewall functionality.
diag		Run diagnostic tests on the card.
getmachashindex		Display the hash index value for a specific source and
destination		IP address combination.
linkup
		Enable the physical link.
[output omitted]

92 Appendix A