
OPERATION | CHAPTER 4: OPERATION |
4.2Multilink ML1200 Managed Field Switch Port Modules
This chapter describes each Port Module (PM), including appearance, functionality, and status displays.
4.2.1Inspecting the Package and Product
This section applies only to Port Modules shipped as separate items, i.e., ML1200 PMs that are not factory installed.
Examine the shipping container for obvious damage prior to installing a ML1200 PM; notify the carrier of any damage you believe occurred during shipment. Inspect the contents of this package for any signs of damage and ensure that the items listed below are included.
The package should contain:
•1 or more ML1200 Port Moduless
•Installation instructions with illustrations
Observing proper ESD grounding procedures, remove the ML1200 PM(s) from the shipping container. Be sure to keep the shipping container should you need to ship any of the PMs separately at a later date. In the event there are items missing or damaged, contact your supplier. If you need to return the unit, use the original shipping container if possible. Refer to Chapter 5 for specific return procedures.
4.2.2ML1200 Modules
An important feature of the Multilink ML1200 is the use of Port Modules for flexible mixed- media connectivity to
The ML1200 Port modules are not identical to the port modules used in other Multilink products such as the ML2400 and ML1600. For information about other Multilink products, please see the applicable manual. For a list of ML1200 Port Modules, refer to Section 2.1.
Each ML1200 Port Module (PM) is individually described in the sections that follow.
For the fiber modules in slot D, the operational description is the same as the corresponding fiber modules configured in slots B and C described below.
4.2.2.1 C8 Module, 2@100Mb
The C8 Module is two port ST fiber module at 100MB. The module is equipped with dual- mode
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL |