GE ML1200 Displaying configuration, Syntax show config module=module-name, System

CHAPTER 5: IP ADDRESSING IP ADDRESSING

5.4.3Displaying configuration

Using SWM, the need to display specific CLI commands for configuring capabilities is not needed. The menus are modular and are alphabetically sorted to display each necessary component in a logical manner. This section is repeated from the CLI manual, should the need arise to view the necessary commands. The best way to view these commands is to telnet to the switch using the Telnet menu from the Administration menu.

To display the configuration or to view specific modules configured, the ‘show config’ command is used as described below.

Syntax show config [module=<module-name>]

Where module-name can be:

Name	Areas affected
system	IP Configuration, Boot mode, Users settings (e.g. login
	names, passwords)
event	Event Log and Alarm settings
port	Port settings, Broadcast Protection and QoS settings
bridge	Age time setting
stp	STP, RSTP and LLL settings
ps	Port Security settings
mirror	Port Mirror settings
sntp	SNTP settings
llan	VLAN settings
gvrp	GVRP settings
snmp	SNMP settings
web	Web and SSL/TLS settings
tacacs	TACACS+ settings
auth	802.1x Settings
igmp	IGMP Settings
smtp	SMTP settings

If the module name is not specified the whole configuration is displayed.

ML1200# show config

[HARDWARE]

type= ML1200

slotB=8 Port TP Module

##########################################################

MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL 5–17