GE ZET1R, ZET2R owner manual Care and Cleaning, Oven lights, To remove, To replace, NOTE: If

Care and Cleaning

Wall Oven

Oven lights

Each oven is equipped with two halogen light assemblies located on the side walls of the oven. The lights come on when the door is opened or when the oven is in a cooking cycle. The oven lights do not come on during self-cleaning or if the Sabbath Feature is set.

Each light assembly consists of a removable light cover with two locking clips, a light compartment with three light bulb sockets and three halogen light bulbs.

CAUTION: Before replacing the bulb, disconnect electrical power to the oven at the main fuse or circuit breaker panel.

Be sure to let the light cover and bulb cool completely.

For your safety, do not touch a hot bulb with bare hands or a damp cloth.

To remove:

Remove the racks from the oven. See the Full extension oven racks section.

Using an adjustable wrench, remove the four nuts holding the rack support over the light assembly.

Remove the glass light cover by pulling its back edge out and rolling it toward you.

Do not remove any screws.

NOTE: The two locking clips may fall from the glass light cover. Upon replacement, they will need to be placed in the correct position on the light cover and pressed back into the light compartment until seated.

Using gloves or a dry cloth, remove the burned-out light bulb by pulling it straight out.

To replace:

Use a new 120-volt Halogen bulb, with G8 pins, not to exceed 25 watts.

Replacement bulbs may be purchased by calling 800.626.2002. Order Part Number WB25T10064.

NOTE: Higher wattage bulbs will damage your oven.

Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers. Oil from bare fingers may cause hot spots on the glass surface and lead to premature failure of the bulb. If you do touch the glass, clean it with alcohol prior to installation.

Push the bulb straight into the receptacle all the way.

Replace the light cover, by placing its

front edge under the front two tabs in the light compartment. Roll the back edge into place, making sure that it is firmly seated.

NOTE: If		Hold	Place front
the locking	locking		edge of
			lens cover
clips fell	clips in
	place on		under
from the
	lens cover		front two
glass lens cover,	back edge		tabs
hold them on the
cover, in the correct
position, while
replacing the cover on		Press the light cover
the light compartment.		into place

The light cover must be in place when using the oven.

For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is off, disconnected from the power supply, and completely cool.

Replace the rack support with the slotted holes over the rear bolts and the round holes over the front bolts. Lightly secure with the four nuts removed earlier, but do not over-tighten or the enamel could be chipped.

Slotted	Round
holes	holes
over	over
rear	front
bolts	bolts

Replace the racks. See the Full extension oven racks section.

Reconnect electrical power to the oven. 45