Hitachi GR2000 Status RM, Power, Ready, Error, Alarm, Post Disp, Status Code, Accesso, Status RP

GR2000 Installation Guide

Switch and LED indication

Table 3-3 RMP switch and function of LED indications

Name of switch	Switch or LED	Status	Content
and LED
STATUS (RM)	LED: Green/	Shows the	Green: Operable operation
	Yellow/ Red	operating	Yellow: Blocked
		condition of RM.	Green blinking: Under preparation (being started up.)
			Red: Fault or shutdown
			Extinguished: Operation not possible (Including the device
			power supply being turned off)
POWER	LED: Green	Shows the state of	Green: Voltages of 5V and 3.3V of RMP are normal.
		power supply	Extinguished: Voltages of 5V and 3.3V of RMP are not the
		turned on or off.	specified voltage.
			(Fault in power supply unit or RMP board, or power supply
			switch in device is turned off, or AC power is not fed.)
READY	LED: Green	Shows the	Green: Operable operation
		operable condition	Extinguished: Operation not possible (Including the device
		of the device.	power supply being turned off)
ERROR	LED: Yellow	Shows partial fault	Yellow: Partial fault has been developed in the device.
		in the device.	Extinguished: Occurrence of partial fault is not detected.
			(Including the device power supply being turned off.)
ALARM	LED: Red	Shows	Red: Partial fault has occurred in the device.
		occurrence of fault	Extinguished: Operation possible. (Including the device
		in the device.	power supply being turned off.)
POST DISP	LED: Green	Shows the state	Green: Shows the state that STATUS CODE (7 seg) is
		that STATUS	indicating the initial diagnosis code of RM-CPU.
		CODE is	Extinguished: Shows that STATUS CODE (7 seg) is
		indicating the	indicating the contents of FAULT CODE. (Including the
		initial diagnosis	device power supply being turned off.)
		code of RM-CPU.
STATUS CODE	7 seg for	7 seg. Decimal	Green: Indicates the device state code for 00~99. (Code
	indicating the	and two digits.	contents differ by lighting of POST DISP LED.)
	device		Extinguished: Non-indication. (Including the device power
	condition.		supply being turned off.)
ACCESSO	LED: Green	Shows the state of	Blinking: MC card zero being accessed. (Memory card
		MC card being	take-out is prohibited.)
		zero.	Extinguished: MC card zero being idle. (Memory card may
			be put in or taken out.)
ACCESS 1	LED: Green	Shows the state of	Blinking: MC card one being accessed. (Memory card
		MC card being	take-out is prohibited.)
		one.	Extinguished: MC card one being idle. (Memory card may
			be put in or taken out.)
STATUS (RP)	LED: Green/	Shows the	Green: Operable operation
	Yellow/ Red	operating	Yellow: Blocked
		condition of RM.	Green blinking: Under preparation (being started up.)
			Red: Fault or shutdown
			Extinguished: Operation not possible (Including the device
			power supply being turned off.)
STATUS (NIFE)	LED: Green/	Shows the	Green: Operable operation
	Yellow/ Red	operating	Yellow: Blocked
		condition of XIF2	Green blinking: Under preparation (being started up.)
		(built-in Ethernet).	Red: Fault or shutdown
			Extinguished: Operation not possible (Including the device
			power supply being turned off)
LNK/ACT	LED: Green		Green: Ring pulse of 10BASE-T or 100BASE-TX is being
			established.

3-6	GR2K-GA-1002
	Rev. 6.03