Hitachi manual GR2000 Installation Guide GR2000-2S, RMP NIF1 NIF0

GR2000 Installation Guide

GR2000-2S

The GR2000-2S incorporates one BCU with one 10M/100M Ethernet (4 ports), and one POW. The BCU consists of one RMP (equivalent of RM and RP) physically packaged in one RM-CPU module and one RMP module with one 10M/ 100M Ethernet (4 ports). Up to two NIFs can be installed on the GR2000-2S. Power supply redundancy is not available on this model.

The front view is shown in Fig. 2-10, the front appearance view of GR2000-2S, and the rear view in Fig. 2-11, the rear appearance view of GR2000-2S.

Memory	LED (status
card slot	indicator)

88

FAN3

Mounting position of

RMP and NIF board.

RMP

NIF1 NIF0

RS-232C port
(for console)	Integrated Ethernet port (10M/100M) x 4

Figure 2-29 Front View of GR2000-2S

FAN1

FAN2

FAN4

Power switch	Mounting position of RM-CPU and power supply
	RM-CPU with POW
	unit (device integrated type)
Power cord receptacle

Figure 2-30 Rear View of GR2000-2S

GR2000-4S

This model incorporates one BCU, one RP, and one POW; the BCU consists of one RM physically packaged in one RM-CPU module and one RM-IO module. Up to four NIFs can be installed on this model. Power supply redundancy is made available by mounting one optional POW in the POW1 slot; otherwise, only the base POW is mounted in the POW0 slot. BCU redundancy, available on higher models, is not available on this model.

The front view is shown in Figure 2-31, the front appearance view of GR2000-4S, and the rear view in Figure 2-32, the rear appearance view of GR200-4S.

2-22	GR2K-GA-1002
	Rev 6.03