Hitachi GR2000 manual Network Interface NIF, Adding an RP, Removing an RP FreerprpnoCR

8.5.2.1Adding an RP

To add an RP:

1.Mount the RP board in an empty RP slot.

2.To start the RP, enter the following command from your terminal:

8.5.2.2 Removing an RP freerp<rp_no>[CR]

To remove an RP:

1.[config:]maintenanceStop the RP by entering the following command:

2.Even if the NIF under thecloseRP isrprunning,<rpno>[CR]it will stop.

3.Make sure the LED on the RP is yellow.

4.Remove the RP board.

For further information about commands, see the Operations Guide.

8.5.3Network Interface (NIF)