Hitachi GR2000 manual NWVX-4, NE1G-1LB NE1G-1LHA, Name LED Color Status Content

GR2000 Installation Guide

Table 3-20 Connector Specifications for NE1G-1S, NE1G-1SA, NE1G-1L, NE1G-1LA, NE1G-1LHA, NE1G-1LHA8, NE1G-1SB, NE1G-1LB and NE1G-1LHBA

NIF	Connector Specifications
NE1G-1S, NE1G-1SA,	SC 2-core (flat) connector (multimode fiber, 850 nm wavelength)
NE1G-1SB
NE1G-1L, NE1G-1LA,	SC 2-core (flat) connector (multimode/single-mode fiber, 1300 nm wavelength)
NE1G-1LB
NE1G-1LHA,	SC 2-core (flat) connector (multimode/single-mode fiber, 1500 nm wavelength)
NE1G-1LHA8,
NE1G-1LHBA

3.5.4NWVX-4

The NWVX-4 physically appears as Figure 3-25. This NIF has four ports for V.24/ X.21/V.35 connections via half-pitched 50-pin connectors on the router side, which require specific connector pin assignments for respective interfaces. See Table 3-23, Table 3-24, and Table 3-25 for the connector specifications.

STATUS

LINE3 LINE2

LINE ERR

ACT

T/R

LINE1	LINE0		V.24
			V.35
LINE3		LINE1	X.21
LINE2		LINE0

NWVX-4

	Figure 3-25 NWVX-4 Front Panel View
	Switch and LED indication
	Table 3-21	NWVX-4 switch and function of LED indications
Name	LED: Color		Status	Content
STATUS	LED: Green/		Shows the operating	Green: Operable operation
	Yellow/ Red		condition of NIF	Yellow: Blocking and the board replaceable state.
				Green blinking: Under preparation (Program being
				loaded.)
				Red: Fault
				Extinguished: Operation not possible (Including the
				device power supply being turned off)
T/R	LED: Green		Shows the operating	LED: Green
			condition of each line.	Green: State of transmission and reception signals in line.
ACT	LED: Green			Line operation (open) state.
LINE ERR	LED: Yellow			Yellow: Line fault detection.

3-22	GR2K-GA-1002
	Rev. 6.03