up the MPLS network must be RP-D, RP-DV or RP-C, RP-CV. RP-A and RP-A1 will not operate.
In addition, in regard to the conditions of NIFs that support MPLS functions, NIF conditions that accommodate MPLS backbone circuits are shown in Table 4-47 and NIF conditions that accommodate MPLS access circuits are shown in Table 4-51 Refer to Figure 4-7 for the location of MPLS backbone and access circuits.
There are non-utilizable RP types depending on the mode of the MPLS protocol used. These are shown in the table below.
Table 4-46 Protocol types in MPLS and non-utilizable RP types
| MPLS protocol mode | Configuration defining mpls | | |
| information protocol | RP-C, RP-D | RP-CV, RP-DV |
| and IP-VPN system |
| parameter setting | | |
| | | |
| | | | |
| LDP(DoD)/CR-LDP mode, | cr-ldp | O | O |
| LSP allocation system for | | Usable. | Usable. |
| each VPN | | | |
| | | | |
| LDP (DU) mode, RFC2547 | ldp-unsolicited | X | O |
| bis system | | Not usable. | Usable. |