Holder C 9.92 H operating instructions Operating the hydraulic accumulator* front lift

C 9.92	Operating Instructions
	Operating the attachments

Operating the hydraulic accumulator* (front lift)

The hydraulic accumulator allows the ground pressure of the attachment to be decreased steplessly and the front axle load to be increased. This improves the climbing ability.

-Press key (5). The LED indicator (7) will come on.

The electronic pressure sensor (2) with a digital display al- ways shows the current pressure of the front lift with the float position turned off.

-Press the „MODE“ key (3).

-S.P.1 will appear in the display. After 2 seconds the current setting will flash.

-If you want to change the setting, press key (1) to reduce the value or key (4) to increase the value until the ground pressure of the machine is changed as desired.

-The value S.P.1 must be less than the pressure with a lifted attachment.

NOTE

After 3 seconds without key activation the display will revert and the settings will be stored.

* Option

1 2 3 4 5 6

7 Bild_C188

Adjusting control sensitivity (hysteresis)

-Press the „MODE“ key (3) twice within 3 seconds.

-HYS.1 will appear in the display. After 2 seconds the current setting will flash.

-Press key (1) to reduce the value or key (4) to in- crease the value if you want to change the setting. The value should be between 5 and 10 bar.

NOTE

The gas pressure in the diaphragm accu- mulator is 30 bar.

153 146 103