C 9.92

Operating Instructions

Operating the attachments

 

Flow rate limiting for joystick

1Key for individual flow rate limiting for each individual joystick function

-Turn on the master switch for the working hydraulics.

With the flow rate limiting you can save the lifting or lower- ing speed individually.

-Operated the joystick (4) until the desired speed at the cylinder is reached, then press key (1).

This value will be stored as the maximum value and will apply for the entire joystick stroke.

If the full volume flow is required again, proceed as follows:

-Move the joystick (4) as far as possible and press key (1).

The full volume flow will be enabled again for the full joy- stick stroke.

Setting key for float position button

2Key for setting the joystick button (3) to „float posi- tion of front lift“

-Press key (2).

1

2

3

4

5

Bild_C212

 

The button (3) will now also be activated as float position button for the front lift.

Two flashing LED indicators show the operating state.

NOTE

You can also activate and de-activate the float position with the button (3).

The LED indicator (5) shows the operating state.

-To reverse the selection, press key (2) again.

153 146

95

Page 97
Image 97
Holder C 9.92 H operating instructions Flow rate limiting for joystick, Setting key for float position button