C 9.92

Operating Instructions

General remarks on maintenance

 

Do not run the engine in enclosed spaces! Danger of poisoning!

To prevent the danger of fire, always keep the tractor and attachments clean!

When leaving the tractor unattended, secure it against rolling and unauthorized use (parking brake, chocks), stop the engine, remove the ignition key and lock the cabin, if necessary!

Never leave the tractor unattended if the engine is still running!

If external electric power loads are connected (eg equipment with solenoid valves), protect them with diodes against back currents. If not, the traction elec- tronics could be affected.

Operate the equipment only if all guards are installed and in position.

Install and remove the articulated shaft only with the engine stationary.

When working with the PTO, no-one should be standing in the area of the rotating PTO and articulated shaft.

The guards for the articulated shaft and the PTOs must be installed as specified.

When the articulated shaft is removed, refit the protec- tive cap on the PTO.

Do not do any welding, cutting and grinding on support- ing parts and other safety-relevant parts such as the tractor frame, axles, trailer coupling, etc.

Before doing electric welding, disconnect all connec- tors from the electronic system.

The mounting of tires requires sufficient knowledge and specified mounting tools.

Only use genuine HOLDER replacement parts! Use the parts listed in the list of replacement parts in the section entitled „Maintenance data“.

Always check the tractor and the attachment for road- worthiness and operating safety before taking the trac- tor into operation and after maintenance or repair serv- ices!

153 146

155

Page 157
Image 157
Holder C 9.92 H operating instructions General remarks on maintenance