Holder C 9.92 H operating instructions Maintenance after the first 50 service hours, 168

Operating Instructions	C 9.92
Maintenance after the first 50 service hours

Checking the coolant level, topping up if necessary

-Park the tractor on a level surface.

-Raise the dumping subframe and secure it against accidental lowering.

-Turn off the engine and allow it to cool.

The coolant level should be between the min. and max. marks on the expansion reservoir (4) when the engine is cool.

Add coolant if the coolant level is below the min. mark.

ATTENTION

Do not remove the cap when the engine is hot. Danger of scalding!

-Remove the cap (3) on the expansion reservoir (4) and add coolant.

Observe the mixing ratio of anti-freeze/cooling water.

-Refit the cap (3).

If there is no more coolant in the expansion reservoir, the radiator (2) must first be filled fully with coolant.

ATTENTION

Do not remove the cap when the engine is hot. Danger of scalding!

12

3

4

Bild_S 990_034

-Remove the cap (1) and top up the radiator (2) with coolant.

-Refit the cap (1).

-Remove the cap (3) of the expansion reservoir (4) and fill coolant up to the max. mark.

-Refit the cap (3).

-Check the coolant level again, adding coolant if necessary.

-Lower the dumping subframe.

168