HP 100 COLOR CE866ABGJ Enww, Interpret control panel messages, Control panel message, Description

Control panel message	Description	Recommended action
Memory is low	The product does not have enough memory	If the product is processing other jobs, send
Press [OK]	to process the job.	the job again after those jobs have finished.
		If the problem continues, turn off the power
		by using the power switch, and then wait at
		least 30 seconds. Turn on the power and
		wait for the product to initialize.
		Break the job into smaller jobs that contain
		fewer pages.
		Resend the print job in raster mode.
		Set the “Print Data Optimization” setting in
		the print driver to “Optimize for Raster”.
Memory is low. Only 1 copy made.	Product memory is too low to complete this	Either copy fewer pages at a time or turn off
Press [OK] to continue	job.	collation.
		If the error persists, turn the product off, and
		then on.
Misprint	The product has experienced an internal	1.	Reprint the pages.
Press [OK]	hardware error.	2.	If the error persists, turn the product
			off, and then on.
		3.	Print the pages again.
		4.	If the error persists, contact HP. See
			www.hp.com/support/
			LJColorMFPM175 or the support flyer
			that came in the product box.
No paper pickup	The product has experienced an internal	1.	Verify that the media was inserted far
Press [OK]	hardware error.		enough into the input tray.
		2.	Load the tray with the correct size of
			paper for your job.
		3.	Make sure the paper guides in the tray
			are adjusted correctly for the size of
			paper. Adjust the guides so they are
			touching the paper stack without
			bending it.
		4.	Check the product control panel to see
			if the product is waiting for you to
			acknowledge a prompt to feed the
			paper manually. Load paper, and
			continue.
		5.	If the error persists, contact HP. See
			www.hp.com/support/

LJColorMFPM175 or the support flyer that came in the product box.

ENWW Interpret control panel messages 145