| Type | Description |
| Protocol Identity | Indicates protocols supported on the port. An LLDPDU can carry |
| multiple different TLVs of this type. | |
|
| |
|
|
|
| DCBX | Data center bridging exchange protocol. |
|
|
|
|
|
|
NOTE:
HP devices support only receiving protocol identity TLVs.
•IEEE 802.3 organizationally specific TLVs
Table 73 IEEE 802.3 organizationally specific TLVs
Type | Description | ||
MAC/PHY | Contains the rate and duplex capabilities of the sending port, support for | ||
autonegotiation, enabling status of auto negotiation, and the current rate | |||
Configuration/Status | |||
and duplex mode. | |||
| |||
|
| ||
| Contains the power supply capability of the port: | ||
| • Port class (PSE or PD). | ||
Power Via MDI | • | Power supply mode. | |
• Whether PSE power supply is supported. | |||
| |||
| • Whether PSE power supply is enabled. | ||
| • Whether pair selection can be controllable. | ||
|
| ||
| Indicates the support of the port for link aggregation, the aggregation | ||
Link Aggregation | capability of the port, and the aggregation status (or whether the link is in an | ||
| aggregation). | ||
|
| ||
Maximum Frame Size | Indicates the supported maximum frame size. It is now the MTU of the port. | ||
|
| ||
| Indicates the power state control configured on the sending port, including | ||
| the following: | ||
Power Stateful Control | • Power supply mode of the PSE/PD. | ||
| • | PSE/PD priority. | |
| • | PSE/PD power. | |
|
|
| |
The power stateful control TLV is defined in IEEE P802.3at D1.0. The later versions no longer support this TLV. HP devices send this type of TLVs only after receiving them.
•
Table 74
Type | Description |
Allows a network device to advertise the | |
|
|
| Allows a network device or terminal device to advertise the VLAN ID of the |
Network Policy | specific port, the VLAN type, and the Layer 2 and Layer 3 priorities for specific |
| applications. |
|
|
| 220 |