HP CLI commands

Logging in to the CLI

The login process requires a username and password. The default username for first time configuration is admin, no password is required. Usernames and passwords are case sensitive.

To log in to the CLI:

1.Press Enter. The Username prompt displays:

Login authentication

Username:

2.Enter your username at the Username prompt.

Username:admin

3.Press Enter. The Password prompt appears.

Password:

The login information is verified, and the following CLI menu appears:

<HP 1920 Switch>

If the password is invalid, the following message appears and process restarts.

% Login failed!

CLI commands

This section contains the following commands:

Task	Command
Display a list of CLI commands on the device.	?
Reboot the device and run the default configuration.	initialize
Configure VLAN-interface 1 to obtain an IPv4 address through	ipsetup { dhcp ip-address ip-address{ mask
	mask-length} [ default-gateway
DHCP or manual configuration.
	ip-address ] }
Configure VLAN-interface 1 to obtain an IPv6 address through	ipsetup ipv6 { auto address { ipv6-address
	prefix-length ipv6-address/prefix-length }
the autoconfiguration function or manual configuration.
	[ default-gateway ipv6-address] }
Modify the login password.	password
Log out of the system.	quit
Download the Boot ROM image or system software image file	upgrade [ ipv6 ] server-address
from the TFTP server and specify it as the startup configuration
	source-filename{ bootrom runtime }
file.
Reboot the device and run the main configuration file.	reboot
View the summary information about the device.	summary
Ping a specified destination.	ping [ ipv6 ] host
Tear down the current connection and quit the system.	quit

24