3.Set the camera height.

Insert the camera height gauge as shown in Fig. 5-9below.

Raise or lower the camera enclosure so that it touches the top of the gauge.

Camera enclosure

Fig. 5-9. Camera height measurement point

4.Tighten the camera enclosure mounting screws.

5.Replace carriage cover and screws.

6.Press ! to return the carriage to the service station.

The control panel displays a message asking whether you want to calibrate the service station. See “Calibrate the Ser- vice Station” on page 5-17for instructions.

7.Press " to calibrate the service station, or ( to continue.

The control panel displays a message asking whether you want to perform a bidirectional (bidi) calibration.

8.Press " to perform a bidi calibration, or ( to continue.

9.Observe a Purge-n-Wipe cycle to ensure that the service sta- tion wipers are centered and properly deflected during a wipe.

◆If the wipers are not centered, see “Calibrate the Service Station” on page 5-17for instructions.

◆If the wipers do not touch the service station or are over- deflected, see “Calibrate the Service Station” on page 5- 17 for instructions.

10.Calibrate the position of the camera (image sensor) by peforming an Image Sensor Calibration (see “Image Sensor Calibration” on page 4-23).

5-16

Set the Printhead and Camera Height