HP 72SI, 98SI manual Expert/Novice Messages Novice mode presents Warn

◆ Quality Check — determines how AutoTune errors are han- dled (see “Auto Calibrations” on page 4-20 for information

	about AutoTune).
	◆ Print Position — when the printed image does not span the
	entire width of the media, positions the printed image flush
	right (nearest the control panel), flush left (nearest the cap-
	ping station), or centered on the media.
MEDIA WIZARD	◆ Stiff Roll-Fed Media Handling — when enabled, detensions
	then retensions the takeup system before every print job, for
	more accurate feeding of adhesive-backed and other stiffer
	roll-fed media types.
	◆ Standby Wait — sets the period of time to wait for a print job
	before going into standby mode, which turns off the heat-
	ers and detensions the supply and takeup system.
	◆ Expert/Novice Messages — Novice mode presents Warn-
	ings (alerts that do not prohibit printing) and Actions (con-
	ditions that require user intervention before printing can
	proceed). Expert mode presents Actions only, presents fewer
	“press Proceed” prompts after an Action has been addressed.
	The default is Novice mode.
	When in Expert mode, active Warnings and Actions can be
	displayed by selecting Warnings & Actions from the menu,
	since Warnings will not cause the ATTN icon will appear in
	Expert mode. See “User Assistance” on page 2-3 for further
	information about Actions and Warnings. See “Warnings &
	Actions” on page 2-16 for further information about this
	menu option.
	◆ Audible Alarm — enables and disables the audible alarm
	beep that sounds with Warning and Action messages.
	◆ Localization — allows you to select units of measure (metric
	or English), time format (12-hour or 24-hour), and date for-
	mat (YYYY-MM-DD, MM-DD-YYYY, and DD-MM-YYYY).
	◆ Head Height — moves the printhead carriage over the platen
	so you can adjust the head height. See “Set the Printhead
	and Camera Height” on page 5-12 for instructions.
	◆ Service Station — allows you to set the alignment and height
	of the service station wipers. For instructions, see “Calibrate
	the Service Station” on page 5-17.
	◆ Automatic Eject (cut sheet printing only) — when enabled,
	the sheet is automatically ejected at the end of the print job.
	When disabled, the next job(s) will print on the same sheet
	until there is no more room to print.

Menu 2-13