HP 98SI, 72SI manual Loading Ink, When to Load Ink, Loading a Full Ink Box, Off OK

Loading Ink

When to Load Ink

Unloading an Empty Ink Box

Loading a Full Ink Box

The amount of ink in the ink box is tracked by the printer soft- ware and recorded on its corresponding profiler. When the ink box is almost empty, the LED above the corresponding profiler will blink. You should replace the ink box with a full ink box of the same color ink as soon as possible. The status of each ink box and profiler is indicated by the LEDs as follows:

◆Off — OK

◆Slow Blink — profiler is being verified after insertion

◆Fast Blink — low ink warning (300 ml remaining)

◆On — ink system action (ink empty, ink pump failure, pro- filer error, or other), see control panel

1.Remove the profiler.

2.Lift the box out of its holder and turn the box upside down so the ink tube is pointing up.

3.Lift the retaining clip on the ink tube connector and disen- gage the tube from the ink box.

4.Remove and dispose of the ink box (refer to the MSDS for proper disposal procedures).

1. Open the new ink box and locate the supply connector.

Fig. 3-2. Ink box with supply connector

3-10 Loading Ink