HP 98SI, 72SI manual IS-90 91 92 93 94 color Pump

	Table B-1. Actions and Warnings
Code, Message	Cause	What to Do
A-IS-[80 81 82 83]- [color] Heads Not	Printheads for color(s) indicated do	Fill the affected printheads with ink.
Loaded with Ink	not have ink loaded: K (80), C (81),	See “Set the Printhead and Camera
	M (82), or Y (83)	Height” on page 5-12.
A-IS-[84 85 86 87] - [color] Ink Sensor	The on-head ink sensor for the	Reconnect the ink sensor. Contact
Disconnected	color(s) indicated is disconnected.	your Authorized Service Provider or
		MacDermid ColorSpan Technical
		Support for instructions.

A-IS-[88 89 8A 8B] - [color] Air Sensor	The on-head air sensor for the
Disconnected	color(s) indicated is disconnected.

Reconnect the air sensor. Contact your Authorized Service Provider or MacDermid ColorSpan Technical Support for instructions.

A-IS-[90 91 92 93 94] - [color] Pump	The pump indicated is disconnected.	Reconnect the pump and restart the
Disconnected		printer.
A-IS-100 - Excess Ink Bucket Full	The excess ink and solvent reservoir	Empty and dispose of the excess ink
	below the supply reservoirs is full.	and solvent according to local regula-
		tions.
A-IS-[106]- Ink Counting Not Working The ink counting mechanism has		Check docking station cables.
	failed.

A-IS-[10C]- Ink Counting Not Working The ink counting mechanism has failed.

Restart the printer. If the problem persists, contact your Authorized Ser- vice Provider or Technical Services.

A-IS-120 - OHS Read/Write Failure	Failed to communicate with OHS
	board.

Reseat the profilers and ensure they are inserted correctly. Check OHS board cable connections. If the prob- lem continues after resetting this error, contact your Authorized Ser- vice Provider or MacDermid Color- Span Technical Support.

W-IS-[1 2 3 4] - [color] Low Ink		The ink box indicated is low on ink.	Replace the ink box soon.
W-IS-5	- Cleaning Solvent Low	The cleaning solvent box is almost	Replace the cleaning solvent box
		out of cleaning solvent.	soon.
W-IS-6	-	The cleaning solvent profiler is not	Install the cleaning solvent profiler.
Cleaning Solvent Missing Profiler		detected.
W-IS-7	- Out Of Cleaning Solvent	The cleaning Solvent reservoir is	Purging will be disabled until you
		empty.	replace the cleaning solvent box.

W-IS-8 - Replace Ink Filters	The reservoir filters need to be
	replaced.

Replace the reservoir filters. (See “Replace Ink Filters” on page 5-19 for instructions.)

W-IS-9 - Incorrect Cleaning Solvent	The profiler in the cleaning solvent
Profiler	slot is not a cleaning solvent profiler
	or is the wrong type.

Replace the profiler with appropriate cleaning solvent profiler.

WS-IS-A - Invalid Cleaning Solvent	Cleaning solvent profiler is not valid. Replace cleaning solvent profiler.
Profiler

B-10 Diagnostics