MIB descriptions
COLUBRIS-PUBLIC-ACCESS-MIB
This MIB is used to manage public access settings in Colubris access controller devices. It includes status information and the list of authenticated users.
COLUBRIS-PUBLIC-ACCESS-MIB OIDs
publicAccessStatus
.1.3.6.1.4.1.8744.5.1.1.1.1read-only
Identifies the current status of the authentication system.
publicAccessStatusChangedCause
.1.3.6.1.4.1.8744.5.1.1.1.2read-only
Identifies the last cause of a status change. Mostly used by the publicAccessStatusChanged trap.
publicAccessDeviceUserName
.1.3.6.1.4.1.8744.5.1.1.2.1read-write
Specifies the username that the device uses when authenticating itself to a RADIUS server.
publicAccessDeviceUserPassword
.1.3.6.1.4.1.8744.5.1.1.2.2read-write
Specifies the password the device uses when authenticating to a RADIUS server. For security reasons, this should be set only if SNMP traffic is sent through a VPN tunnel. Reading this attribute will return an empty string.
publicAccessDeviceSessionTimeoutAdminStatus
.1.3.6.1.4.1.8744.5.1.1.2.3read-write
Specifies the interval of time between two consecutive authentication attempts in minutes. At each successful authentication the device configuration is refreshed. This is not the time between RADIUS Access Request when an authentication is proceeding without answers. For that element, see the RADIUS Profile definition.
publicAccessDeviceSessionTimeoutOperStatus
.1.3.6.1.4.1.8744.5.1.1.2.4read-only
Identifies the interval of time between two consecutive authentication attempts in seconds. At each successful authentication the device configuration is refreshed. This is not the time between RADIUS Access Request when an authentication is proceeding without answers. For that element, see the RADIUS Profile definition.
publicAccessDeviceConfigMode
.1.3.6.1.4.1.8744.5.1.1.2.5read-only
Identifies how configuration of the device is performed. This can be via locally configured settings on the device, or retrieved from a AAA server. If both options are enabled, the settings retrieved from the AAA server overwrite the local configuration settings.
publicAccessDeviceAuthenProfileIndex
.1.3.6.1.4.1.8744.5.1.1.2.6read-only
Identifies the AAA server profile to use to authenticate the device. This attribute only applies when publicAccessDeviceConfigMode is set to ’profile’ or ’localAndProfile’. When the special value zero is specified, no AAA server profile is selected.