MIB descriptions

COLUBRIS-PUBLIC-ACCESS-MIB

„publicAccessUserMaxReceiveRate

.1.3.6.1.4.1.8744.5.1.1.3.6.1.31read-only

Specifies the maximum receive rate for the user.

„publicAccessUserBandwidthControlLevel

.1.3.6.1.4.1.8744.5.1.1.3.6.1.32read-only

Specifies the user’s bandwidth control level.

„publicAccessUserNASPort

.1.3.6.1.4.1.8744.5.1.1.3.6.1.33read-only

Specifies the NAS-Port value assigned to the user.

publicAccessUsersLoggedInTrapEnabled

.1.3.6.1.4.1.8744.5.1.1.3.7read-write

When set to enable, the publicAccessUsersLoggedInTrap is generated.

publicAccessUsersLoggedInTrapInterval

.1.3.6.1.4.1.8744.5.1.1.3.8read-write

Interval between publicAccessUsersLoggedInTrap traps. Setting this to 0 will disable periodic sending of these traps.

publicAccessNASPortCount

.1.3.6.1.4.1.8744.5.1.1.4.1read-only

Indicates the number of NAS-Port supported.

publicAccessNASPortTable

.1.3.6.1.4.1.8744.5.1.1.4.2not-accessible

A table containing specific information for NAS-Port by the Access Controller. In tabular form to allow multiple instances on an agent.

„publicAccessNASPortEntry

.1.3.6.1.4.1.8744.5.1.1.4.2.1

not-accessible

Information about a particular NAS-Port by Access Controller. publicAccessNASPortIndex - Uniquely identifies a NAS-Port in the table.

„publicAccessNASPortIndex

.1.3.6.1.4.1.8744.5.1.1.4.2.1.1not-accessible

Index of a NAS-Port in the publicAccessNASPortTable.

„publicAccessNASPortUserName

.1.3.6.1.4.1.8744.5.1.1.4.2.1.2read-only

Indicates the user’s name currently authenticated by the Access Controller on this NAS- Port.

COLUBRIS-PUBLIC-ACCESS-MIB Traps

publicAccessStatusChangedTrap

.1.3.6.1.4.1.8744.5.1.2.0.1

This notification is sent whenever the authentication system status changes (up or down).

Parameters: publicAccessStatus,publicAccessStatusChangedCause.

3-40