HP Integrity iLO 2 MP 5991-6005 Power Regulator, 17lists the fields, buttons, and descriptions

Table 6-16 Power Meter Readings Page Description (continued)

Fields and Buttons	Description
Maximum Power	Displays the maximum power reading from the server over the last 24-hour period. If
	the server has not been running for 24 hours, the value is the maximum of all the
	readings since the server was booted.
Minimum Power	Displays the minimum power reading from the server over the last 24-hour period. If
	the server has not been running for 24 hours, the value is the minimum of all the
	readings since the server was booted.
Show values in BTu/hr	Changes the displayed data from watts to BTu/hr. and from BTu/hr. to watts.
Refresh Data	Refreshes the data graph.

Power Regulator

The Power Regulator page (Figure 6-19) enables you to view and modify the power efficiency regulator mode of the system.

The Power Regulator feature is available on systems where support is provided by the operating system, processors, processor dependant hardware (PDH), System Firmware (SFW), and iLO firmware.

The following is required in order to use this feature:

•You must have the power control right to view and modify the power regulation modes.

•To access power and thermal history or the power regulator through IPM, requires both an IPM license and an iLO (select or advanced ) license.

NOTE: Power regulation does not require the Advanced Pack license.

Figure 6-19 Power Regulator Page

NOTE: The BL c-Classtab is available only on HP Integrity server blades.

Table 6-17lists the fields, buttons, and descriptions.

Web GUI 107