HP Integrity iLO 2 MP 5991-6005 Target map1/enetport1/lanendpt1/ipendpt1, ipendpt1 Properties

cd	Changes the current default target.
help	Displays context-sensitive help.
show	Displays information.

Target: map1/enetport1/lanendpt1/ipendpt1

The ipendpt1 target represents the iLO IP endpoint settings.

Table 6-43shows ipendpt1 target properties.

Table 6-43 ipendpt1 Properties

Property Name	Description
IPv4Address	iLO 2 MP IP address.
SubnetMask	iLO 2 MP subnet mask.
AddressOrigin	Used to indicate the configuration
	method that resulted in the
	configuration being assigned to this
	ipendpt.

Access and Values

Read/write

The value of the property must be expressed in dotted decimal notation.

Read/write

The value of the property must be expressed in dotted decimal notation.

Read-only

The following are valid values:

Static: The iLO 2 MP IP address and subnet mask were assigned statically.

DHCP: The iLO 2 MP IP address and subnet mask were acquired using DHCP.

Verbs
cd	Changes the current default target.
help	Displays context-sensitive help.
show	Displays information.
set	Sets a property to a specific value.

Target: map1/dhcpendpt1

The dhcpendpt1 target represents the iLO 2 MP DHCP client.

Table 6-44shows dhcpendpt1 target properties.

Table 6-44 dhcpendpt1 Properties

	Property Name	Description	Access and Values
EnabledState		Represents the state of iLO 2	Read-only
		MP DHCP.	The following are valid values:
			Enabled: The iLO 2 MP DHCP client is enabled.
			Disabled: The iLO 2 MP DHCP client is disabled.
OtherTypeDescription		Textual description of this	Read-only
		protocol endpoint.	Set to DHCP.
Verbs
cd	Changes the current default target.
help	Displays context-sensitive help.
show	Displays information.
start	Enables iLO 2 MP DHCP.
stop	Disables iLO 2 MP DHCP.

SMASH Server Management Command Line Protocol 139