Command line usage and scripting:

LS [ -nc ] -?

See also: DNS, LC, SA

PC: Power control access

Command access level: Power control access

PC enables control of the power management module. It provides the following options for remote control of system power:

ON

Turns the system power on. This command has no affect if the power

 

is already on.

OFF

Turns the system power off. This command is equivalent to turning

 

the system power off at the front panel switch. There is no signal sent

 

to the OS to shut the software down before power is turned off. To

 

turn the system off gracefully, ensure that the OS is shut down before

 

running this command.

CYCLE

Turns the system power off, then on. The delay between off and on

 

is 30 seconds.

Graceful Shutdown

The BMC sends a signal to the OS to shut down prior to turning off

 

the system power.

Command line usage and scripting:

PC [ -on -off -graceful -cycle ] [ -nc ] -?

Example:

[gstlhpg1] MP:CM> pc -on -nc PC -on -nc

System will be powered on.

-> System is being powered on. -> Command successful. [gstlhpg1] MP:CM>

See also: PR, PS

PM: Power regulator mode

Command access level: Power control access

PM provides the following options for remote control of the system power regulator:

Dynamic

Enables the system to dynamically change the processor power level when needed

 

based on current operating conditions. The system remains in this mode unless the

 

system is reset or an OS-hosted application requests a processor state change. In

 

these cases, power management mode changes to OS Control Mode.

Low

Sets the processor to the lowest supported processor state and forces it to stay in

 

that lowest state until the system is reset. If the processor is reset, the power mode

 

changes to OS Control Mode.

High

Sets the processor to the highest supported processor state and forces it to stay in

 

that highest state unless the system is reset or an OS- hosted application requests a

 

state change. If the processor is reset, the power mode changes to OS Control Mode.

OS

Sets the control of the power regulator to the OS.

Command line usage and scripting

Text User Interface

75

Page 75
Image 75
HP Integrity iLO 2 MP 5991-6005 manual PC Power control access, PM Power regulator mode