HP Integrity iLO 2 MP 5991-6005 manual Using the SM CLP Interface, Mpcmsa

3.Use the following example as you follow the prompts on the screen to change the default interface from MP Main Menu to SM CLP.

MP:CM>SA

This command allows you to modify MP access configuration.

Current Set Access Configuration:

R - Remote	: OS SESSION
T - Telnet	: Enabled
H - SSH	: Disabled
W - Web SSL	: Enabled
I - IPMI over LAN	: Enabled
C - Command Mode	: MP Menu

Enter parameter(s) to change, A to modify All, or [Q] to Quit: c c

For each parameter, enter: New value, or

<CR> to retain the current value, or DEFAULT to set the default value, or Q to Quit

Default Command Mode Configuration:

Current -> M - MP Menu (default)

S - SM CLP

Enter new value, or Q to Quit: s s

-> Default Command Mode Configuration will be updated

New Set Access Configuration (* modified values):

R	- Remote	: OS SESSION
T	- Telnet	: Enabled
H	- SSH	: Disabled
W	- Web SSL	: Enabled
I	- IPMI over LAN	: Enabled
* C	- Command Mode	: SM CLP

Enter Parameter(s) to revise, Y to confirm, or [Q] to Quit: y y

-> Set Access Configuration has been updated.

MP:CM>

Using the SM CLP Interface

After initiating an SM CLP session, the iLO CLP prompt appears. Each time a command is run, the CLP prompt appears as shown in the following example.

<current default target>hpiLO->

Where <current default target> is your current target.

Each time a CLI command runs, the output follows this general format:

</> hpiLO-> {CLPcommand} status=0 status_tag=COMMAND COMPLETED

... command output returned...

</>hpiLO->

If you enter an invalid command, the status and status_tag values reflect the error as shown:

</> hpiLO-> badcommand status=2

status_tag=COMMAND PROCESSING FAILED error_tag=COMMAND NOT RECOGNIZED

SMASH Server Management Command Line Protocol 125