NOTE: To print a configuration page to verify the installed firmware version before or after the update process, click Print Config.

g.Follow the on-screen instructions to complete the installation, and then click the Exit button to close the utility.

4.Verify that the fax was set up when the printer software was installed. From the computer, in the HP program folder, run the Fax Setup Utility.

5.Verify that the telephone service supports analog fax.

● If using ISDN or digital PBX, contact your service provider for information about configuring to an analog fax line.

● If using a VoIP service, change the Fax Speed setting to Slow (V.29) from the control panel. Ask if your service provider supports fax and for the recommended fax modem speed. Some companies might require an adapter.

● If you are using a DSL service, make sure that a filter is included on the phone-line connection to the printer. Contact the DSL service provider, or purchase a DSL filter if you do not have one. If a DSL filter is installed, try another filter because filters can be defective.

Solve general fax problems

●Faxes are sending slowly

●Fax quality is poor

●Fax cuts off or prints on two pages

Faxes are sending slowly

The printer is experiencing poor phone line quality.

●Retry sending the fax when the line conditions have improved.

●Check with the phone service provider that the line supports fax.

●Turn off the Error Correction setting.

a.Open the Setup Menu menu.

b.Open the Service menu.

c.Open the Fax Service menu.

d.Open the Error Correction menu.

e.Select the Off setting.

NOTE: This can reduce image quality.

●Use white paper for the original. Do not use colors such as gray, yellow, or pink.

●Increase the Fax Speed setting.

ENWW

Solve fax problems 161